Federal Signal Cuda TriOptic

Edit:

The model has been released here: Federal Signal Cuda TriOptic

Two released cars can found here:

File

2013 Chevrolet Caprice PPV - Los Santos Police Department - Unmarked

An unmarked LSPD 2013 Chevrolet Caprice PPV 9C1 with Federal Signal Cuda TriOptic, based on LAPD's unmarked cars. Featuring Kane104's amazing Caprice model.

Cj24

October 8, 2017 at 10:14 AM

File

2013 Chevrolet Caprice PPV - Los Santos Police Department - Slicktop

A slicktop LSPD 2013 Chevrolet Caprice PPV 9C1 with Federal Signal Cuda TriOptic, based on LAPD's slicktop cars. Featuring Kane104's amazing Caprice model.

Cj24

October 2, 2017 at 4:26 PM

______________________

Hey,

It's been a while since the last time I scratch-modeled anything, so yesterday I decided to start working on an FS Cuda TriOptic and surprisingly, it's already mostly finished today. I'm going to add a mount, a glare visor and LODs before trying it in-game. The current poly count is 600, however it has a diffuse, spec and normal map that are each 256x256px.

Update: Mount (both facing up and down) and visor done, all together 1000 polygons.

Thanks for all the positive feedback, I appreciate it!

I've tested it earlier in V and modified the textures a little bit, but I believe there's still room for improvement, so it'll take a little bit longer until I can show in-game screenshots. However, the LODs are finished:

L0: 1082 Polygons

L1: 506 Polygons

L2: 110 Polygons

L3: 102 Polygons

Almost finished, there're just some very minor problems with the mapping of the screws and the directions of the normal map. Here are a few in-game screens:

The emissives:

Edit: Quick update, normal map is fixed. Would've probably been better to wait with this post until that was done, but well...

Unlike I stated previously, I kept my original 512x512 textures. The size difference shouldn't be relevant and scaling it down, if ever necessary, is easier than to add more details.